This Z-Wave module is used for energy measurements in single-phase electrical power network till 65A. Meters measure energy directly in 2-wire networks according to the principle of fast sampling of voltage and current signals. A built-in microprocessor calculates energy, power and power factor from the measured signals.

The module can be controlled through Z-wave network and it acts as repeater in order to improve range and stability of Z-wave network.

It is designed to be mounted on DIN rail.

item also available in:
908.4 MHz - USA/Canada, México, Chile
921,40 MHz - Australia, Brazil, New Zealand
Contact for details on minimal quantities and deadlines for these frequencies

The Qubino three-phase smart meter can be used in many automation scenarios that make your life more comfortable. Smart Meter is an extremely versatile and powerful instrument for measuring energy in a three-phase power network up to 65A. A built-in microprocessor calculates the power, reactive power and power factor with the measured values. The smart meter is designed to be mounted on a DIN channel. The Qubino Smart Meter can be used in residential, industrial and commercial facilities. This equipment permanently measures the current and voltage in a three-phase network. Calculate the current and total power, the PHI power factor and the reactive energy that is actually consumed. The control through Z-Wave allows to act the relays (available separately), as well as to evaluate the results of the measurements of the device. With the energy data we can carry out the most varied actions, such as being alerted if the consumption exceeds a certain limit, sliding loads to keep the consumption below a certain level, etc.

to work with ZWGOA ZMNHTD1 Smart Meter
wired connection
Voltage: 230V ± 10%, 50-60Hz
Current: 32A, 2 pole

to work with ZWGOA ZMNHTD1 Smart Meter
Infra-red connection
Voltage: 230V ± 10%, 50-60Hz
Current: 32A, 4 pole

Temperature sensor can be installed behind this 2M casing SET. It is suitable for mounting on boxes Ø60 with claws. SET consists of: 1 x cover plate1, 2 x 1M perforated blank cover and 1 x mounting frame 2M with claws. 2M casing SET is made of PC/ABS material and comes in 2M dimensions. 2M casing set is available in polar white colour.

Din rail enclosure that can be used to mount Fibaro modules on DIN rails.

Expander for CMEB box.
It fits on the side of the CMEB and it makes it 17,5mm wider and adds 8 terminals.

SPU-DIM-C02 can control single colour LED strips from a standard push switch or from a 0-10V or 1-10V from any manufacturer. The controller can be connected to one or more push switches (check wiring diagram) or with 0-10V or 1-10V signals

Qubino Shades Remote Controller is 9 Channel Z-Wave standard handheld product. The World‘s 1st Z-Wave remote for shades control (Z-Wave secondary controller).