The MCS-730 two-way, self-powered fully wireless outdoor siren (IP55) provides the perfect security solution for home owners looking for an external siren that is both affordable and easy to install. It excels in offering cabling-free installation and optional extended time between battery changes. The siren's two-way, fully supervised communication with the control panel and two diversity antennas assure highly reliable operation and optimal wireless performance, including visual and audial notifications of intrusions, fire alarms, low battery voltage, and communication disruptions. In addition, the siren provides auditory squawk notifications of arming and disarming the security system. In the event of an alarm, the siren sound is extremely loud, ensuring the alarm is noticed. The sleek design ensures the MCS-730 siren is clearly visible from almost every angle. This makes it highly effective at alerting and deterring potential intruders, while maintaining the clean external look of any building.
The Next+ K9-85 MCW is a PowerCode™ wireless digital PIR detector designed to enable homeowners to secure their homes while allowing their pets to move freely anywhere in the house. Employing Visonic's patented "Target Specific Imaging" optical system (TSI™) and unique pet identification software algorithm, the Next+ K9-85 has an unprecedented capacity to reliably distinguish between human bodies and pets weighing up to 38 kg (85lb).
The MCT-211 is a PowerCode™ miniature waterproof wrist-worn transmitter, designed for personal emergency signaling and other applications where the transmitter needs to be within easy reach at all times. The transmitter is waterproof and suitable for wearing even in a shower or in other wet environments such as factories, hospitals, gardens, pools and rain conditions. Attractive ergonomic design makes the MCT-211 as convenient to wear on a regular basis as any wristwatch.
The detector indicates fire hazards using the built-in LED indicator and alarm outputs ALARM and TAMPER. These outputs must be connected to control panels complying with EN 50131-3. The SD-282 ST consists of two independent detectors – an optical smoke detector and a heat detector. The optical smoke detector works on the principle of scattered light and is very sensitive to dust particles which are present in smoke. There is also a built-in heat detector for detecting fire which generates heat quickly with a small amount of smoke. The microprocessor performs digital analysis for a high false-alarm immunity.
The MCT-241 is a PowerCodeTM miniature, microprocessorcontrolled personal UHF transmitter. It is designed to transmit coded alert signal in distress or in other emergency situations. The transmitter is waterproof and suitable for wearing in a shower. The transmitter is activated by depressing the recessed oval pushbutton at the center of the unit. A built-in timer determines the transmission time to 3 seconds, even if the user maintains the transmission button depressed shorter or longer than that. When triggered, the transmitter transmits a unique, factory programmed, randomly selected 24-bit digital alarm code. This code is selected from 16 million possible codes and is therefore unique and virtually impossible to reproduce. Operating power is obtained from an internal 3V Lithium battery. A red LED (see Fig. 1) lights steadily during the transmission, giving reassurance to the user and indicating that the battery condition is good. If the LED flashes each time the transmitter is activated, it indicates that the battery voltage is low and must be replaced as soon as possible. The transmitter case is sealed (no screws) to enable the waterproof feature. Therefore, battery replacement can only be done in the factory. If the transmitter is activated while the battery voltage is low, a ‘low battery’ alarm code is transmitted. If the transmitter is not activated for a long period, the battery is self-tested every 12 hours. After three consecutive “low battery” states, a supervisory ‘low battery’ alarm code is transmitted. The transmitter is supplied with two wearing accessories, a neck cord (to be worn around the neck) and a clip (to be attached to the user belt or shirt pocket). The neck cord includes a built-in safety release mechanism. This neck cord must never be replaced with a cord that does not include a safety release.