The JA-82M designed to detect opening windows, doors etc.

The JA-84P provides human body movement detection including visual alarm verification.

The JA-80PB consists of two independent detectors which occupy two separate enrollment addresses in the control panel. The motion detector uses a PIR sensor. The glass-break detector uses the analysis of air pressure variations combined with the characteristic sound of glass breaking. The product is designed for internal use in buildings. The battery-powered detector communicates via OASIS radio protocol.

The JA-89P is an outdoor intruder detector designed to detect human body movement in a protected area. It supplements a double-zone PIR sensor produced by Optex with a Jablotron transmitter enabling the sensor to be used within JA-80 OASiS systems.

The JA-80P is designed to detect human body movement inside buildings. The detection pattern can be modified by optional lenses. Detector immunity has two selectable levels. The battery-powered detector communicates via OASIS radio protocol.

Detects shock and tilt on doors, windows etc. caused by an intruders attempts to force, smash, drill, or saw through. Has easy installation and uses digital signal processing. Features a memory of previous shocks.
The detector is a component of the JABLOTRON ALARMS Oasis security system. It has two selectable operation modes. The mode for the detection of shocks / vibrations of doors, windows, etc. can be used to indicate attempts to breach these by force.
The tilt detection mode can be used to indicate unwanted tampering with the object to which the detector is firmly fixed. This may be used for safes, artworks etc.
The detector uses a semiconductor tri-axial accelerometer with digital output. Its signal processing guarantees a high immunity against false alarms.
The detector communicates wirelessly using Oasis protocol and it is battery powered.

The detector indicates room water floods (e.g. cellars, bathrooms). This information is sent to an alarm system for alert message transmission. It is connectible to an Oasis alarm system via a JA-81M wireless detector. Plug it into the IN1 input terminal (red wire) and GND (black wire). If the detector is triggered (e.g. by a water), it sends a trigger signal. If the detector goes into a stand-by condition, it sends a non-triggered signal. The LD-81 takes its power supply from the JA-81M´s circuit.
It is possible to use the LD-81 with an older type of detector, the JA-60N, for Profi systems if you insert a 4k7 resistor in series with the LD-81 between the INP (red wire) input terminals and GND (black wire).