Two load lamp in-wall module (refurbished)

The LW12 is an in-wall module with built-in dimmer that can be installed behind existing momentary switches or wall outlets.

The LW12 can be controlled with X10 signals via the mains or a momentary switch connected to the LW12. The LW12 has a memory setting for the last dimmer setting and uses SoftStart and SoftDim. The LW12 is the only X10 module that doesn't use a zero wire. This means it can replace a switch without having to use any extra wiring.

The AW 12 reacts to the standard X10 commands that are: "All Units On", "All Units Off", "All Lights Off" from any X-10 controller set to its house code regardless of unit code or alternatively individual unit control by "On" an "Off" commands.

House code and unit code are programmed using any X10 compatible controllers. There is an EEPROM that stores the house and unit code even when the power is cut.

We would like to point out that this article is not a new product. The product has got the complete functionality and can be used without restriction. However, the product may have the following characteristics:

broken seal,
damaged packaging,
no original packaging
missing accessories,
minimal signs of wear,
no current software version.

We offer a guarantee of one year. With a possible return you receive a credit note, there is no exchange of the product. The picture may not correspond to the scope of delivery of the product.

The Uni-Remote is designed to control up to 8 devices: TV, VCR, CBL(decoder, set top box), ASAT (analog satellite receiver), DSAT (digital satellite receiver) or any other device under AUX mode key. The Uni-Remote contains a library of codes thar are preprogrammed into the remote control. This library covers nearlly all the audio video products on the market today. The codes have to be programmed once before use.

This module was designed to control electric shutters or curtains.
X10 compatible.